Page 11 of 17
Place the unit in the shade if possible and in a cool, protected place in order to
increase efficiency and to avoid overheating. At an ambient temperature of over 32°C, the
unit will stop cooling protecting the compressor. If this become recurrent we recommend
you use the INDOOR COOLING OPERATION. We recommend that drainage hose for
condensation water must be connected.
Set the function to „COOLING“. The selectable temperature range is between 17°C and
30°C. Fresh cold air with high oxygen content cooled by the unit is led into the room via the
air hose.
The hose can be vented v
ia a tilted
window, a door or wall aperture.
Make sure that no
warm air
from
outside
can enter the room.
Using the Airflex Comfort Kit will enable wired or wireless control of the air conditioner
from inside the room to be cooled.
Note: After switching on compressor only starts after the 3 minutes. For full cooling
effect please allow a further 10 minutes of operation.
HEATING
Be aware on very cold days only to operate the unit indoors. Note that colder is the outside
temperature the longer it takes to heat the room. We recommend that when you achieved
the desired temperature to leave the unit on thermostatic control and it will maintain the set
temperature very economically.
To improve the heating effect we recommend you remove the top drain port rubber plug
allow the condensation water to drain using the drainage hose. However, the drainage hose
does not have to be connected in the heating mode. Please make sure that the
condensation water outlet is closed with the rubber cap during operation. E4 water tank light
will come up regularly and you will need to drain the internal tank.
Heat pump operating range is 7°C-23°C when placed indoor. It will work if the outside
temperature is less than 7°C but the indoor temperature should be higher than 7°C. You
may want to quicker heat the room with an electric radiator and only maintain the
temperature achieved cheaper using the heat pump air conditioner.
HEATING WHEN AC IS PLACED INDOOR
Connect the cold air hose as displayed in the illustration after exchanging the grills. The air
hose will expel the cold air from the room outside while the front grills produce hot air.
The hose can be vented via a tilted window, a door or wall aperture. Make sure that no cold
air from outside can enter the room. For effective heating, we recommend
through the wall
venting.
Set the function to „Heating“. The selectable temperature range is between 15°C and 25°C
temperature.
Note: After switching on compressor only starts after the 3 minutes. For full heating
effect please allow a further 10 minutes of operation.
(16 Seiten)
(19 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern